1.Put a towel next to the car box, with a flat head screwdriver pry the car logo, shop towel is to prevent scratches the body
2. Note that the first double-sided adhesive stripping the body, pry when the force is moderate, do not be too fierce, little by little, slowly pry down, clean the car and the body of the double-sided adhesive.
3. Use a Phillips screwdriver to remove the inside of the box, pay attention to some places have a clip, be careful to remove the noise board can see a variety of lines.
4. Now come to install the car lights, car lights power line through one of the car positioning hole, wear the inside of the car to tear off the side of the standard single-sided plastic, while pulling the side of the car lights to the car body, pressure tight.
5. car lights installed, and now connected to power. Car lights to be connected to the license plate after the lights power, so when the lights opened when the lights will also open the lights
6. First pull out the plug, positive and negative stripping a hole, exposing the wire core, according to the red on the red, black on the black line, do not forget to use insulating tape wrapped, and finally re-plug the plug back! Replace the rear cover insulation board.
Ford bronco logo light 2020+ front led ford bronco emblem light Infiniti logo car led front emblem light Chevy logo Silverado kurrod 1500 front led chevrolet logo light Toyota emblem 2014-2017 Prado front led toyota symbol light Toyota logo 2018-2021 Prado/ 2016-2021 Land Cruiser led front toyota symbol light Nissan logo Nissan Patrol Y62 Armada 2013-2020 led front nissan symbol light Nissan symbol light Nissan Altima（2013-2018 ）X-Trail led front nissan emblem light Lexus logo light LX570/ LS460 led front symbol light Buick logo led front buick symbol light fit 2017-2020 Regal / LaCrosse / Enclave / ENVISION Audi logo A3 S3 A4 A5 A6 A8 Q1 Q3 Q5 Q7 led front audi symbol light LED Rearview Mirror Light Turn Signal For Infiniti Q30 QX30 Q50 QX50 Q60 QX60 Q70 Q70L QX70